Thermo Tracer TH9100 PMV / PWV / PMVI / PWVI
Firmware Update Download

Update Contents

This update consists of the following.
Adding the emissivity setting function on the thermal imaging screen

How to Update

When upgrading, follow the instructions below. Failure to do so may damage the embedded flash memory in the TH9100 main unit,
causing improper operation. If the TH9100 does not function correctly,
it must be repaired by Nippon Avionics. (Repair available at cost.)


  1. TH9100 Firmware Program is exclusive for TH9100 main unit. Be sure not to use the upgrade firmware for other models such as TH7102MV/WV. Check the name plate on bottom of the main unit for the model number.
    name plate
  2. Please don't upgrade the firmware in the main unit of special edition.
  3. Always use the AC adapter for power supply when upgrading the firmware. Do not use batteries while upgrading, in order to avoid accidental power supply interruption.
  4. Never remove the compact flash card during firmware upgrading.
  5. If the thermal image data recorded in the TH9100PMVI/PWVI is required, back up this data before performing the upgrade.

2.Required Equipment

  1. Compact flash card (formatted, 16 Mbytes or larger)
  2. Personal computer with a PC card reader, compact flash card reader, or PC card slot.
    (A PC card adapter is required when using a compact flash card with a PC card reader or PC card slot,.)


  1. Download th9100Pro.exe to a folder.
  2. Copy the "th9100Pro.exe" file onto a root folder of the compact flash memory card.
  3. Double-click the "th9100Pro.exe" icon and below files are uncompressed on the root folder. Make sure all of the below folders are present:
    Firmware program: TH_LOAD.CMP
    Update contents file: ReadmeENG.txt (English)
    Update contents file: ReadmeJPN.txt (Japanese)
  4. Confirm that the TH9100 main unit is turned off. If the power is turned on, turn off the power first, then connect an AC adapter. Insert the flash card that includes the firmware program into the TH9100 main unit.
  5. Turn on the power while pressing the E key in the TH9100 main unit. Keep pressing the E key.
    Never pull out the compact flash card during firmware upgrading.
  6. After 10 to 30 seconds following power-up while pressing the E key, the update screen (Ver2.0 or Ver3.0) of the TH9100 main unit appears. Firmware upgrading starts. Release the E key after this screen is displayed.
    Update screen (Ver2.0)
    Update screen (Ver2.0)
    Update screen (Ver3.0)
    Update screen (Ver3.0)
  7. Update completes after a few minutes, then below initialization screen appears.
    Initialization screen
    Initialization screen
  8. Make sure the camera starts up normally and below Run screen is displayed.
    Run screen
    Run screen

4.Version Display

Follow below instructions and check if updated version is identical to the version shown on the initially uncompressed file.

  1. Go to "SETUP" on menu and select "VERSION", then press the E key.
  2. The Version screen shows up as follows.
    Version screen
    Version screen



The file to download:

How to Obtain TH9100 Series Operation Manual

To obtain the TH9100 Series Operation Manual, send the following order form to Nippon Avionics Co., Ltd. The manual will be sent via e-mail after confirmation of the model and serial number.

To Top of  Page

Infrared Thermal Imaging Camera Support
Micro Joining Equipment
Infrared Thermal Imaging Camera
Infrared Thermal Imaging Camera
Intelligent Projector
Company Profile
Company's Outline
Contact Us
Micro Joining Equipment
Infrared Thermal Imaging Camera
Multi-Layered Board (
Radiation Hardened POL DC/DC CONVERTER (